This website uses cookies to ensure you get the best experience on our website. Please read our Privacy Policy & Legal Disclaimer.

Service Manuals

SERVICE MANUALS

REEL TINES

The angle of the reel tine can be adjusted by means of cam roller mounting support.

Note:- Adjusting the tines of reel to much to the rear causes the reel to wrap.

CONCAVE ADJUSTMENT

A screw type lever is provided on the LHS of the Operator seat. The gap between thresher & concave can be adjusted by rotating that nut in Clock wise or anti clock wise Position. After above setting, Still of adjustment is not proper then it can be adjusted mechanically by loosing or tightening the nut bolts provided on both sides.

ELEVATOR CHAIN TENSION

To adjust the tension of elevator chain, loose the clamping bolts on the both sides of elevator & lock Nut of adjustment screw, Tension of elevator chain can be done by tightening the nut & bolts provided on both side of elevator head for the adjustment.

Note:- Tighten the elevator chains upto such extent as to prevent the rubber pads from rubbing the elevator housing.

AIR DEFLECTION ADJUSTMENT

Two air deflectors are provided in the blower for adjustment of air flow, The air flow can be increased or decreased by adjusting that deflectors upwards and downwards with the help of hands provided.

SIEVE ADJUSTMENT

Adjustable sieves are provided to obtain the required cleaning of grains sieves, should be adjusted in such a way for all crop, to give a gap wide enough to allow all un-threshed material fall & join the tailing auger casing. A lever is provided on the sieve to adjust the gap between both the sieves.

CHANGER PULLEY ADJUSTMENT

Speed changer Pulley can be adjusted Vertically & Horizontally

CONTROL PANEL

Control panel is provided for operating the combine harvester meter, levers & electrical switches available in control board used for operating the harvester.